P3P2640CA1 Markel Downflow Unit Heater

SKU:

MARKEL717618

Manufacturer: 

TPI (Markel/Raywall/Fostoria)

More Information
UPC/GTIN Code 686334717618
Manufacturer Part Number P3P2640CA1
Manufacturer TPI (Markel/Raywall/Fostoria)
Voltage 480 Volt
Phase 3 Phase
Wattage 40000 Watt
Control Voltage 24 VAC
Depth 21.5 Inch
Length of Product 27 Inch
Width of Product 27 Inch
Finish Epoxy Powder Coat
Air Throw -
Air Flow 3300 CFM
Type of Product Downflow Unit Heaters
Product Condition New
Heater Type Downflow Unit Heaters

Features of Markel P3P2640CA1 Electric Downflow Unit Heater


The Markel 2600 Series Electric Downflow Unit Heater is a commercial grade unit heater.

  • CONSTRUCTION: 16 Gauge steel cabinet with epoxy powder coated finish and control compartment with a hinged and latched access door.
  • OSHA guards standard with all models.
  • HEATING ELEMENT: Corrosion resistant element with steel sheath and steel spiral fins.
  • OVERHEAT PROTECTION: All units come equipped with manual reset limit controls to de-energize the heater should an over-temperature situation occur.
  • FAN and MOTOR: Totally enclosed, 1 speed, 1 phase permanently lubricated, thermally protected motors with unit bearings on 3KW thru 20KW models. Totally enclosed, 2 speed, 1 phase permanently lubricated, thermally protected motors with sleeve bearings on 24KW thru 50KW models.
  • Axial flow fan blade - 1570 RPM max.
  • All models equipped with fan purge which allows fan to operate after elements are de-energized to purge residual heat.
  • TEMPERATURE CONTROLS: 208V, 240V, 277V and 480V units have In-Built 24 Volt transformer for low voltage remote thermostat application.
  • 600V units have In-Built 240V control on 5-20 KW models, 25-50 KW models have 24V control.
  • 25 KW - 50 KW models may operate as 2 stage heaters if 2 stage remote thermostat is used.
  • DISCONNECT SWITCH: All models equipped with In-Built disconnect except F3F2640, F3F2650 and H3H2650.

Additional Information


The Markel 2600 Series Electric Downflow Unit Heaters can be mounted using an OPTIONAL mounting bracket or a field constructed angle iron bracket.

NOT recommended for mounting with threaded rod or chain.