UPC/GTIN Code | 686334688420 |
---|---|
Manufacturer Part Number | H1HUH20CA1 |
Manufacturer | TPI (Markel/Raywall/Fostoria) |
Voltage | 240 Volt |
Phase | 1 Phase |
Wattage | 20000 Watt |
Control Voltage | 24 VAC |
Depth | 17 Inch |
Width | 24 Inch |
Height | 17 Inch |
Finish | Powder Coat |
Air Throw | 56 Feet |
Air Flow | 1350 CFM |
Type of Product | Horizontal Discharge Unit Heaters |
Product Condition | New |
Heater Type | Horizontal Discharge Unit Heaters |
Features of Markel H1HUH20CA1 Horizontal Fan Forced Electric Unit Heater
The Markel UH Series Fan Forced Electric Unit Heater is designed for use in areas that require a heavy duty heater such as warehouse and shipping areas.
- CONSTRUCTION: Heavy Gauge welded steel cabinet with powder coated finish and control compartment with a hinged and latched access door, simplifying wiring installation and maintenance.
- HEATING ELEMENT: Circular copper clad steel sheath element with continuously brazed steel fins formed to match the air delivery pattern of the fan blade.
- OVERHEAT PROTECTION: All units come equipped with automatic resetting type limit controls to de-energize the heater should an over-temperature situation occur.
- FAN and MOTOR: Totally enclosed, single phase, permanently lubricated, thermally protected motors with unit bearings on 3 KW thru 10 KW models and sleeve bearings on 12.5 KW thru 48 KW models mounted with rubber insulators to minimize vibration and noise. Fan assembly enclosed by a heavy gauge, close spaced, chrome plated wire guard.
- LOUVER ASSEMBLY: Louvers are individually adjustable for directional control of air flow and the entire assembly can be repositioned in the field from down flow to up flow or left/right directional air flow.
- TEMPERATURE CONTROLS: 20 KW through 48 KW units and all 480V have built in 24 Volt transformer for low voltage remote thermostat application. 25 KW through 48 KW models available in 2-stage on special order (consult factory).
- INSTALLATION: Unit Heaters can be mounted with the motor shaft from horizontal to downward at 45F off horizontal. Pre-drilled holes and installed threaded nuts provided to allow hanging by threaded rods 1/4 Inch for units up to 15 KW and 5/16 Inch for 20 KW units and larger. Optional wall/ceiling mounting brackets are available for all units.
Additional Information
Louver assembly is square and mounted with screws. Louver can be removed and repositioned for four (4) directional air flow - left - right - up - down with the heater in the horizontal position.