BriskHeat End of Circuit LED Monitor Light Kits are the ideal solution when working with large lengths of heat trace. This high-profile light with 360° visibility, indicates voltage at the end of the circuit. A super bright green/red light lets you know your heat trace cable is energized and working! Each kit can complete on end of circuit LED monitor light end seal termination.

Kit Contents:

1 - End seal stand and light assembly with O-ring and grommet

2 - 16-14 insulated parallel splice crimps

1 - Silicone lead termination boot

1 - Rubber strain relief grommet

1 - Pipe strap - for 2 in - 6 in (51 mm - 152 mm) O.D. pipes

1 - End seal label

Features:

• Approved for ordinary and hazardous locations
• Voltages up to 240 VAC
• Easy to install – hot work permit not required
• Easy re-entry for maintenance
• Compatible with up to 4 in (102 mm) of insulation and cladding
• Available Light Colors: Green or Red

Specifications:

Maximum Voltage: 240 VAC

Maximum Current: 32 amps

Lumen Output: 10 lumens

Construction: Non-conductive FRP plastic body

Overall Height: 8.2 in (208 mm)

Maximum Continuous Exposure Temperature (T5): 212°F (100°C)

Ambient Exposure Temperature Range: -40°F to 149°F (-40°C to 65°C)

IP Rating: IP66/NEMA 4X

CSAus

Ordinary Locations (with SLCBL, SLMCBL, and SLHCBL heating cables)

Hazardous (Classified) Locations (with SLCBL heating cable only)

• Class I, Division 2, Groups A, B, C, D
• Class II, Division 2, Groups E, F, G
• Class III
• T5: 3,5,8 watts/ft (10, 16, 26 watts/m). T6: 10 watts/ft (33 watts/m)

Approvals valid only when used with appropriate heating cable and installation accessories, and installed in accordance with all applicable instructions, codes, and regulations