Mor Electric HeatingQuestions? 616-784-1121 Email Us8:00am-5:00pm M-F (Eastern Time)Distributor for 75 Manufacturers with Over 1,500 SKUs Typically in Stock for Same Day Shipping
Supplied with a single pole in-built thermostat and a wall/ceiling hanger bracket.
Heavy gauge welded steel cabinet
Powder coated finish
Circular copper clad steel sheath element with continuously brazed steel fins
Automatic reset limit
Totally enclosed, single phase, permanently lubricated, thermally protected motor
Louvers are individually adjustable
ETL-US Listed
Specifications
CONSTRUCTION: Heavy gauge welded steel cabinet with powder coated finish and control compartment with a hinged and latched access door, simplifying wiring installation and maintenance
HEATING ELEMENT: Circular copper clad steel sheath element with continuously brazed steel fins formed to match the air delivery pattern of the fan blade
OVERHEAT PROTECTION: All units come equipped with automatic resetting type limit controls to deenergize the heater should an over-temperature situation occur
FAN and MOTOR: Totally enclosed, single phase, permanently lubricated, thermally protected motors with unit bearings on 3 kW - 10 kW models and sleeve bearings on 12.5 kW - 15 kW models - mounted with rubber insulators to minimize vibration and noise. Fan assembly enclosed by a heavy gauge, close spaced, chrome plated wire guard
LOUVER ASSEMBLY: Louvers are individually adjustable for directional control of air flow and the entire assembly can be repositioned in the field from down flow to up flow or left / right directional air flow
INSTALLATION: The UHE series is supplied with a single pole in-built thermostat and a wall/ ceiling hanger bracket. UHE heater can be mounted in a vertical position only (see FIGURE 1) with the motor shaft from horizontal to downward at 45° off horizontal. Pre-drilled holes and installed threaded nuts provided to allow hanging by threaded rods - 1/4” for units up to 15 kW.
