F1FUHE15C03T 208V 15kW Unit Heater

SKU:

MARKEL742429

Manufacturer: 

TPI (Markel/Raywall/Fostoria)

More Information
UPC/GTIN Code 686334742429
Manufacturer Part Number F1FUHE15C03T
Manufacturer TPI (Markel/Raywall/Fostoria)
Color Almond
Voltage 208 Volt
Amperage 72.9 Amp
Phase 1 Phase
Wattage 15000 Watt
Control Voltage 208 Volt
Depth 11 Inch
Width of Product 15 Inch
Height of Product 22 Inch
Finish Powder Coat
Air Throw 45 Feet
Air Flow 800 CFM
Built In Thermostat? (Y/N) Yes
Mounting Bracket Included (Y/N) Yes
Type of Product Horizontal Discharge Unit Heaters
Product Condition New
Heater Type Unit Heaters
  • Supplied with a single pole in-built thermostat and a wall/ceiling hanger bracket.
  • Heavy gauge welded steel cabinet
  • Powder coated finish
  • Circular copper clad steel sheath element with continuously brazed steel fins
  • Automatic reset limit
  • Totally enclosed, single phase, permanently lubricated, thermally protected motor
  • Louvers are individually adjustable
  • ETL-US Listed
Specifications
  • CONSTRUCTION: Heavy gauge welded steel cabinet with powder coated finish and control compartment with a hinged and latched access door, simplifying wiring installation and maintenance
  • HEATING ELEMENT: Circular copper clad steel sheath element with continuously brazed steel fins formed to match the air delivery pattern of the fan blade
  • OVERHEAT PROTECTION: All units come equipped with automatic resetting type limit controls to deenergize the heater should an over-temperature situation occur
  • FAN and MOTOR: Totally enclosed, single phase, permanently lubricated, thermally protected motors with unit bearings on 3 kW - 10 kW models and sleeve bearings on 12.5 kW - 15 kW models - mounted with rubber insulators to minimize vibration and noise. Fan assembly enclosed by a heavy gauge, close spaced, chrome plated wire guard
  • LOUVER ASSEMBLY: Louvers are individually adjustable for directional control of air flow and the entire assembly can be repositioned in the field from down flow to up flow or left / right directional air flow
  • INSTALLATION: The UHE series is supplied with a single pole in-built thermostat and a wall/ ceiling hanger bracket. UHE heater can be mounted in a vertical position only (see FIGURE 1) with the motor shaft from horizontal to downward at 45° off horizontal. Pre-drilled holes and installed threaded nuts provided to allow hanging by threaded rods - 1/4” for units up to 15 kW.