Features of the ASE MG-6 Replacement Remote Precipitation Sensor

• Cable Length: 10 ft
• Compatible with the Following ASE Controllers: DS-7C, DS-8C, DS-824C and DS-9C

Application Information

Ten feet of cable is pre-terminated to the remote precipitation sensor. This cable may be shortened on the controller end as required. Do not add additional cable to the interface. Erratic operation may result. If the cable must be lengthened only use the EX-50 extension kit. Pass the cable through the strain relief on top of the unit. Strip the outer insulation and shield from the cable and terminate each conductor to the Grid Jack following the color code printed on the circuit board. The bare drain wire should be installed into the terminal marked “S” for Shield. Two cable ties are also included. Wrap these ties securely around the cable in the enclosure to provide additional strain relief between the flexible enclosure gland and the free end of the cable.